VANLONG PUTA
Mašina za sečenje kamena, takođe poznat kao kamen mašine za sečenje, je multi-nož i višestepeni kamen mašina za sečenje sastavljena od sečenje nož grupe, Kamen Transportna platforma, pozicioniranje vodič ploča, Okvir, Itd.
Начин уградње машине за сечење камена
1. Прво поставите две паралелне стазе на земљу, чија је ширина иста као и ширина ходајућег точка резног рама.
2. Поставите оквир на паралелне стазе и померајте га напред-назад тако да стазе буду потпуно конзистентне и да се слободно крећу.
3. Поставите главну машину машине за сечење камена на оквир. Четири ваљка на главној машини морају бити у потпуности у складу са челичним каналом на оквиру. Правац кретања главне машине након постављања је 90 степени укрштају са правцем кретања оквира, и свако може слободно да се креће.
4. Инсталирајте напајање тако да је мотор чврсто повезан са главном машином преко статива мотора, and the direction of the motor axis is horizontally and vertically crossed with the direction of the main machine.
5. Install the belt.
6. Install the protective cover.
7. Start the motor and check that the rotation direction of the saw blade shaft is consistent with the direction indicated by the arrow of the protective cover.
8. Install the saw blade. Connect the water pipe.
Stone cutting machines are widely used because of their high processing efficiency, low production cost and easy use. In order to be able to play these functions normally, the correct installation method must be guaranteed. Стога, mastering the installation method of stone cutting machines is a prerequisite for normal operation.
Stone cutting machine operating procedures
Before work
1. Wear work clothes and goggles. Female workers with long hair should put their hair up and wear work hats.
2. Check the power switch, saw blade tightness, saw blade guard or safety baffle in detail. When operating at night, the operating table must be stable and well lit.
3. Turn on the main switch and test a few turns without load. Only start the machine after confirming safety.
When working
1. It is strictly forbidden to operate with gloves. If dust is generated during operation, a mask or mask should be worn.
2. Do not try to cut small workpieces that are not clamped.
3. This cutting machine is only allowed to cut profiles.
4. Do not perform strong sawing operations. The motor should reach full speed before cutting.
5. Do not allow anyone to stand behind the saw.
6. Do not lean over or get close to the saw. Do not release any hands or arms from the saw or workpiece when the saw blade is not stopped.
7. Do not operate when the protective cover is not in place, and do not put your hands within 15 cm of the saw blade.
8. Before repairing or replacing accessories, the power must be turned off and the saw blade must stop completely.
9. If any abnormal sound is found, the machine should be stopped and checked immediately.
End of work
1. Turn off the main power supply.
2. Clean and organize the workbench and site.